Passages - Layout #5

These two layouts were part of a challenge from one of my customers. See once we're done with the workshop, she pulls out some extra cardstock and uses the scraps to make some extra layouts. (Yes, she's very creative!) So I wanted to use more of the paper so she wouldn't have to come up with design ideas herself. And voila! These layouts came out.

I started with a 6x10 of the map paper on the left-hand page and a 2x6 of the postcard paper along the bottom of it. Then I used a 6x12 piece of the stripe (cut with the strip, vertically) for the other side of the paper. On the edge of this, I put a 1x10 of the postcard paper, leaving 2 inches of the stripe at the top showing. I then cut a 5x2 piece of the postcard paper that lines up in the center of the layout, flush with the edge of the map paper. A 13-inch ribbon with a pewter slide stretches across the page at the bottom of the 2-inch section. The other ribbon is described in depth below.

The right page starts with 2x12 strips of map paper, brown cardstock, and stripe, all lined up next to each other. A 6x6 pocket of the brown B&T makes up the bottom right of the layout. For the top right, I used a 6x6 piece of map paper and a 5x5 postcard cut as a mat on top of it.

I used more of the brown B&T as a tag in the pocket and added a pewter hinge at the top to keep it from falling into the pocket. The general measurement of the tag is 3 x 5. A ribbon is stretched from top to bottom of this layout and a 1x3 piece of postcard adorns the top of the pocket.

The ribbon at the bottom of the left-hand page is knotted on the right side and the resulting loop is slipped over the side of a spiral clip. That clip is then attached to the layout with a brad, like on other pages. I tied another knot around a photo clip and then wrapped the end of the ribbon around the left side of the layout to complete the design.

All-in-all, I was really pleased with this workshop. I used almost all of the paper in the set and ALL of pewter embellishments along with most of the ribbon. I was really pleased with the results of the effort.

Passages - Layout #4

These easy layout were included with the Passage Workshop on the Go kit. I try really hard to make them just like they are shown, but this one begged a change. See the little circle designs are actually four folded circles, like this one.

To make it this way, you fold it in half and then in 1/4 before unfolding it. Then you collapse it so that the two sides fold into the center of two triangular quarters. Then with your thumb, you fold down one top edge of the quarter. It's easier to see the design when using paper that has more of a difference between the back and front. You put 4 of them together to make the complete circle and then put a brad in the center.


I made a much easier version, though, and it only used 2 circles instead of 4. For this one, I used one circle as a base and then folded just a bit of the second circle to make it more of a square. I then put a brad into the center. It doesn't have the folds or bulk of the original, but it is much easier to make and work with.

The top accents are easy with the new Chocolate Ribbon collection. I just anchored one end with a pewter hinge around one edge and wrapped the other end around the other edge of the page. Adding some quick stamps and decorative brads made an easy and fast double layout.

Passages - Layout #3

The designs on these two pages left too much base page showing and I didn't like the effect, so I altered the design to completely cover the bases. The cuts on the left-hand side start with a 1x12 strip of the journaling sheet. The catch with this cut is that it goes across the words so that they will show vertically on the page. All the other cuts are horizontal, with the writing lines. There is a 2x4 cut like that at the bottom right corner of that page. Next to the 1x12 strip of journaling paper is a 1x12 strip of postcard paper. Another postcard cut is a 4x4 at the top right corner. The last base-cover cut is a 6x12, with the lines, on the striped paper. A 5x7 and 4x6 of Brown Bag cardstock finish the collection. The 5x7 sheet is edge-distressed all the way around and the 4x6 has the top edge torn off, just a bit.

On the right-hand page, the top is a 4x12 of the postcard paper. The bottom is a 2x12 of the journaling paper - cut horizontally, with the writing. In the middle of this is a 6x12 of the striped paper, but this time it is cut ACROSS the stripes. That way the stripes will agree between the pages.

The decoration at the top of the left-hand page is worked with a few different cuts. The base is a 1x7 inch scrap of any B&T (I used some postcard paper). On top of that is a 1x12 inch brown B&T paper. I left 1 1/2 inch flat and then made a crease. After a 1/4 inch, I made another crease, then again after 3/4 inches. I continued down the paper, creasing at 1/4 then 3/4 inches until I was left with 1 1/2 inches at the end. On the two ends, I added an open hinge to one and a stamped key hole (stamped in Colonial White) to the other.

At the bottom of the pages, I added a 1-inch strip of Brown Bag, both of them 5-inches long, but torn to differen lengths. On the left-hand page, I embellished with brads and spirals. On the right hand page, I repeated the pleated brown B&T design paper and tucked on end under the torn cardstock and the other one under a pewter photo clip.

The final design, at the top of the right page, started with an upside down 1x8 strip of postcard paper. Along with that, I cut a brown ring out of scrap paper, measuring about 3 inches, and another about 3 1/2 inch circle out of Brown Bag. Both of these I edge distressed, like all the other cardstock pieces. At that point, I folded 1 inch of the postcard strip and secured it with a pewter designer brad and then glued the left edge of the ring to the circle so it would be centered on the Brown Bag circle. Using the entire unit, I stretched the postcard paper to the right edge of the layout and glued it down, flush. Then I glued down the rest of the unit as it layed evenly across the page.

Passages - Layout #2

Not sure why the colors on these pics are different, but be assured they are both from the same paper pack and really do go together. This layout started the postcard paper from the Passages set. It seemed a perfect partner to the journaling paper in the set, so I put them together and mounted on the chocolate cardstock. The open spaces on this layout was key, because the base paper complimented the others perfectly.

The cuts for the left-hand page included a 2x5 and 2x7 of the journaling paper. From the postcard paper, a 5x5 and a 5x7. From the brown B&T I cut 1 1/2 inch squares (3) and punched some circles to go in the squares from the Autumn Terra Cotta cardstock.

The cuts for the right-hand page include, from the journaling paper, two 2x7 strips and a 5x5 and 5x7 from the postcard paper. Again, 3 squares at 2x2 each from the brown B&T and punched circles from the Autumn Terra Cotta cardstock complete the cuts.

On both pages, ribbon from the chocolate collection is used. For the left-hand side, I used an 8-inch piece of ribbon. I tied one end of the ribbon around a metal tag then gathered up the other end tightly until the ribbon was only about 3 inches long from knot to tip. I glued it down with adhesive (usually Liquid Glass - I LOVE Liquid Glass!) letting the knot and tag hang down and I wrapped the other end of the ribbon to the bag and secured it the same way.

On the right-hand side, I used a 14-inch piece of ribbon. I pulled the white strings a little out of one end of the ribbon and tied the strings in a knot, then out of the other end of the ribbon, I gathered up the ribbon tightly until it was 8 inches long. Before I put down the bottom-left postcard paper piece, I glued down the ribbon, putting the knotted end around on the right side of the layout. The other edge of the ribbon tucks under the postcard paper piece about a half inch. I make sure that the gathered section isn't under the postcard paper.

The circle punch that I have has an edge to it, and it is about 1-inch in diameter. I decorated them with spirals, medium brads, and designer brads from the pewter collection.

I lined up 3, vertically, on the right-hand page and the other 3, horizontally, on the left page so that, when placed together, they look like a continuous design.

I know a LOT of people travel - and this set is perfect for photos from those trips, especially European trips. For me, my best trip is to my in-laws in Oklahoma (a peaceful, but not normally chic, destination) so I'm not really sure how I will use these layouts. If you have any ideas, pass them along!

Passages Workshop #1

I'm terribly delayed in posting this workshop! Life and volleyball season has set in!

This is a wonderfully easy layout that I based on the orange and red printed B&T that came with this set. This left page has a 4 x 12 piece of the smokey B&T along the left edge, and a 4 x 8 piece of Chocolate cardstock across the bottom span, about 1 inch from the bottom edge. In the top section, a 6 x 7 inch piece of brown bag cardstock is layered with a 6 3/4 x 4 1/2 piece of chocolate cardstoco as a mat for a focal picture.

I embellished this side with some satin ribbon. I cut it to 15 inches and then cut it in the middle and retied it for extra flair. I also added 3 brads and one picture clip to the focal point mat.

On the right hand page, also based on the orange and red B&T, I put a 6 x 6 smokey B&T in the bottom right corner and a 6 x 6 piece of Brown

Bag cardstock in the bottom left corner.

I put a 3 x 6 piece of the smokey B&T (turned to the back) in the top/left corner for a journaling section and

I'm embellished it with a hinge attached to the top section. I added a chocolate cardstock mat (7 x 5) embellished with a stamped clock face from

the included stampset (in Chocolate) on some scrap paper and cut out. The scrap paper I used was a bit of the postcard B&T I had left over and just happened to have a light impression of the capitol building on it. I added another satin ribbon done the same way to this page.